The final design of my battery pack will consist of parallel and series wiring it is 16 cells four sets of four at 12 volts each pak 100 amps.
I saw an interesting photo on the internet I was curious if this is possible when it comes to the wiring of a BMS or if this might be dangerous?
The packs would you all be wired red to red black to Black to increase amperage I believe the photo speaks for itself when it comes to the BMS wiring.
of course the positive and negative on the center pack would be reversed if this does work and my setup would have four packs instead of three.
Also does anybody happen to know if a BMS will work if not all the battery lines are connected I plan on starting with 4 cells then ad another set when I can.
Of course I can use for separate be a message if I have to.
Thank you for your time
I saw an interesting photo on the internet I was curious if this is possible when it comes to the wiring of a BMS or if this might be dangerous?
The packs would you all be wired red to red black to Black to increase amperage I believe the photo speaks for itself when it comes to the BMS wiring.
of course the positive and negative on the center pack would be reversed if this does work and my setup would have four packs instead of three.
Also does anybody happen to know if a BMS will work if not all the battery lines are connected I plan on starting with 4 cells then ad another set when I can.
Of course I can use for separate be a message if I have to.
Thank you for your time