Spleeft
New Member
- Joined
- Jan 22, 2020
- Messages
- 46
I've spec'd 2 AWG wire to the Samlex PST-600 12 inverter and the manual says to use the provided "pin lug " and not tighten the set screw down on large guage stranded wire. Makes sense. But the provided pin connector is too small for 2 AWG. What are my options to make a good connection? Can I shave a few strands off the 2 AWG wire and make it fit in the provided pin crimp connector?
Pic is my test of actually just sticking the stranded wire end in and tightening it down.
Pic is my test of actually just sticking the stranded wire end in and tightening it down.