Hey everyone I need some help. I just got my 280ah cells with a 200a Daly Smart BMS Common port. I gone over my wiring a dozen times but the BMS won't kick on. I tried the "reset" by touching the P- to the B- on the BMS (while B- is still attached to the battery) and the charger kicks on but as soon as I stop shorting the connection (bypassing the BMS), the charger shuts off. Each cell measures 3.3V, pack voltage 13.2v. I've checked the balance loom with my DMM and a pin into the connector. I've tried with and without the NTC sensor, and my shop is not below 15C. Do I need to do some config to work with my cells?