Hi all,
Quick question with regards to top balancing.
I have 4 Eve 280ah cells I'm about to build into a 12v pack for my camper build.
The cells came with only 4 busbars and at the time of ordering I didn't have the foresight to order extra for top balancing.
I do however have a length of copper c101 flat bar that measures 3 mm thick by 25 mm wide.
My plan is to use this to make 2 busbars for connecting the cells in parallel 1 for the positive side and one for the negative side, then use 2 X 10a bench power supplies to top balance the cells. (Thinking one supply clipped each side of the busbars)
So, would this copper be ok for the bus bars as my concern is that it may be to big??
Any help in this regard would be greatly appreciated.
Thanks in advance, Dave
Quick question with regards to top balancing.
I have 4 Eve 280ah cells I'm about to build into a 12v pack for my camper build.
The cells came with only 4 busbars and at the time of ordering I didn't have the foresight to order extra for top balancing.
I do however have a length of copper c101 flat bar that measures 3 mm thick by 25 mm wide.
My plan is to use this to make 2 busbars for connecting the cells in parallel 1 for the positive side and one for the negative side, then use 2 X 10a bench power supplies to top balance the cells. (Thinking one supply clipped each side of the busbars)
So, would this copper be ok for the bus bars as my concern is that it may be to big??
Any help in this regard would be greatly appreciated.
Thanks in advance, Dave