Hey guys! Very excited to finally wire all my batteries up. Using a Daly "Smart" BMS
I have 4 cells wires in series @ 280aH or so.
Cell 1 negative to the positive after the fuse reads 14V DC
However, on the BMS P- to positive of the fuse, I am reading 10.28VDC
Any ideas why this is? I've only just connected the batteries, not sure if the BMS needs configuring.
I have 4 cells wires in series @ 280aH or so.
Cell 1 negative to the positive after the fuse reads 14V DC
However, on the BMS P- to positive of the fuse, I am reading 10.28VDC
Any ideas why this is? I've only just connected the batteries, not sure if the BMS needs configuring.