John Frum
Tell me your problems
- Joined
- Nov 30, 2019
- Messages
- 15,233
I have an overkill(jbd) bms.
On high cell disconnect the charge path is blocked but the discharge path is still active.
This can be observed by administratively disabling the charge path from the android application.
There is a slight <1volt drop in system voltage but the system voltage doesn't drop to zero.
The discharge path is still active.
If you have a Daly smart bms please do the same test and report back.
My hope is that that the Daly disables both paths and the system voltage drops to 0.
Would like confirmation before I spend money.
On high cell disconnect the charge path is blocked but the discharge path is still active.
This can be observed by administratively disabling the charge path from the android application.
There is a slight <1volt drop in system voltage but the system voltage doesn't drop to zero.
The discharge path is still active.
If you have a Daly smart bms please do the same test and report back.
My hope is that that the Daly disables both paths and the system voltage drops to 0.
Would like confirmation before I spend money.