I just hooked up this Epever Triron 4210n and I'm getting a flashing green battery light as well as a flashing "!" . The book under troubleshooting lists this combination as battery over charge.
I'm using 4x6v - seriesed to 24v, GC2 FLA batteries. I set the battery type to FLA, so assume there are default parameters for charging FLA's at 24v. I have not been able to determine "where" to look to see what those parameters are. I find the booklet a bit disjointed and confusing, it covers too many different SCCs and options I think.
The display reads batteries are 100% at 24.9v. This should not be overcharged. Maybe 100% but not overcharged.
My understanding is this SCC auto detects 12v or 24v input, is this not correct? Is there some place I need to tell it that I am using 24v?
I have 2 x 250w panels hooked up, no errors and showing proper voltage, but no watts/amps.... i assume this is because the SCC says the batteries are charged, correct?
Thank you!
I'm using 4x6v - seriesed to 24v, GC2 FLA batteries. I set the battery type to FLA, so assume there are default parameters for charging FLA's at 24v. I have not been able to determine "where" to look to see what those parameters are. I find the booklet a bit disjointed and confusing, it covers too many different SCCs and options I think.
The display reads batteries are 100% at 24.9v. This should not be overcharged. Maybe 100% but not overcharged.
My understanding is this SCC auto detects 12v or 24v input, is this not correct? Is there some place I need to tell it that I am using 24v?
I have 2 x 250w panels hooked up, no errors and showing proper voltage, but no watts/amps.... i assume this is because the SCC says the batteries are charged, correct?
Thank you!