Fusing Victron Lynx Distributor

[740GLE]

If you install your shunt under the Lynx bar and bolt it down, then you’ll need to shim the Lynx so everything mounts flat.

Ask me how I know, after I drilled out my Lynx to 3/8 to fit my shunt bolt a custom 3/8 to 3/8 copper bar 3” long plus an m10 nut and bolt was all I needed.

 

[grizzzman]

If you install your shunt under the Lynx bar and bolt it down, then you’ll need to shim the Lynx so everything mounts flat.

Ask me how I know, after I drilled out my Lynx to 3/8 to fit my shunt bolt a custom 3/8 to 3/8 copper bar 3” long plus an m10 nut and bolt was all I needed.

It was not that hard to shim, I'm all in on less connections myself.

 

[740GLE]

Agreed, wasn’t impossible just another step. I think I may have used a paint stick.

The blueseas switch was a bit more of a pain.

 

[grizzzman]

Agreed, wasn’t impossible just another step. I think I may have used a paint stick.

The blueseas switch was a bit more of a pain.

Yep