Just trying to calculate voltage drops and wires sizes.
There is approx 50m run from meter to inverters(25mm2 cable installed) and then a further 40m (16mm2 cable installed) run to the house consumer unit.
When the inverter is in utility mode does it reset/bump any voltage drop from the grid back up to 230v?
So for for example: If lose 2.2% of my 230v from meter to inverter. When in utility mode will it send the full 230v onto the house or will it just be a pass through and voltage loss will remain?
Inverters are 3 X growatt SPF 6000es in parallel.
There is approx 50m run from meter to inverters(25mm2 cable installed) and then a further 40m (16mm2 cable installed) run to the house consumer unit.
When the inverter is in utility mode does it reset/bump any voltage drop from the grid back up to 230v?
So for for example: If lose 2.2% of my 230v from meter to inverter. When in utility mode will it send the full 230v onto the house or will it just be a pass through and voltage loss will remain?
Inverters are 3 X growatt SPF 6000es in parallel.