Bought a tesla module for dirt cheap 400$.
Now I've been learning about the schematics. I've attached what I though I wanted to do but that might change depending on your suggestions. I was looking online for a 6S bms but I'm still undecided if I need one since I will rarely pull any high amps. I will use it in my shed where I will draw 1850W max with my power tools. Since I'm opting for a Renogy MPPT which has a lot of safety features for batteries I think I don't need a Victron Battery Protect. I think in the Renogy app I can configure a minimum cell charge or 18V and 24.3V max charge. My inverter is a Vevor 2300W which stops at 19V minimum and 30V maximum input voltage. For cell balancing I purchased the cheap 25$ cell balancer for lithium batteries. I don't need a 24V to 12V converter since I wont use any 12V appliances . Is this safe? Ok ? What would you change ?
Now I've been learning about the schematics. I've attached what I though I wanted to do but that might change depending on your suggestions. I was looking online for a 6S bms but I'm still undecided if I need one since I will rarely pull any high amps. I will use it in my shed where I will draw 1850W max with my power tools. Since I'm opting for a Renogy MPPT which has a lot of safety features for batteries I think I don't need a Victron Battery Protect. I think in the Renogy app I can configure a minimum cell charge or 18V and 24.3V max charge. My inverter is a Vevor 2300W which stops at 19V minimum and 30V maximum input voltage. For cell balancing I purchased the cheap 25$ cell balancer for lithium batteries. I don't need a 24V to 12V converter since I wont use any 12V appliances . Is this safe? Ok ? What would you change ?