Quick question, What does it mean or why would 10C seplos bms revert back to Chinese. I assume I will have to undertake the daunting task of finally installing the comms software on my laptop and figure out how to connect to the bms and reset it to English. I am not looking forward to that. I have read the stories here.. baud rate.. correct ethernet cable, software version, firmware version.... oh how I wish it was just plug in run software connect change and save. Is there an updated list of steps to soften the hurdles on this one. any help is appreciated. I can share pictures of anything anybody needs if needed. its a simple setup of 2 lvx 6048s and 2 mason 280ah kits... grid assist. I just use them in ups mode as the inverters suck working together switching to battery after sun drops down.