I am looking for same info. Manual is a little weak for settings.Hey everyone I finally got my BMS in my 16S battery installed and I’m looking for the safe settings for a 16S EVE 230ah configuration, any chance someone could share their settings?
I'm glad it's not just meI am looking for same info. Manual is a little weak for settings.
I found that I can click on the BMS read at the top left which filled in a lot of the parameters that I was then able to edit, but now when I click BMS write, it gives me an error:I am looking for same info. Manual is a little weak for settings.
anything?I found that I can click on the BMS read at the top left which filled in a lot of the parameters that I was then able to edit, but now when I click BMS write, it gives me an error:
Error
Value check for 'Cycle Count' failed.
Reason: value is less or equal to 0
No Idea where I can change this though
Nothing.anything?
From https://www.mobile-solarpower.com/design-your-own-12v-lifepo4-system.html, a @Will Prowse sister site:Hey everyone I finally got my BMS in my 16S battery installed and I’m looking for the safe settings for a 16S EVE 230ah configuration, any chance someone could share their settings?
These are charge settings, not things a BMS should have anything to do with.
- Absorption: 58V
- Float: 54.4V
- Inverter Cut-off: 42.8V-48V
Yes, of course. Thanks. I have charging on the brain lately....These are charge settings, not things a BMS should have anything to do with.
The BMS is to protect your battery and keep it within its safety bounds: 2.5V and 3.65V. Being a little conservative, I set my BMS just inside these to 2.8V and 3.63V (or something like that). You can set the battery voltage to 16x these cell level values; the cell level limits will likely be hit first because the chances of reaching the extremes with all cells equal is exceedingly small.
Similarly, if you are looking for conservative charging numbers, I only charge to 3.45Vpc (x16 = 55.2V). This is a gentle 100% charge.
After a full charge, i look at where the cells settle in an hour and set the float just below this to keep from micro-cycling (charge, settle, charge, settle...).
This works for me, YMMV.
Did you find the solution to this problem? I am unable to write settings to BMS. Mazing how un helpful the other responses are.Nothing.
Hi
Did you find the solution to this problem? I am unable to write settings to BMS. Mazing how un helpful the other responses are.