[Au]Ray

5.00 star(s) Just now found this here today; as simple as some of these configs may be, to have them all laid out so neatly and in one place with...

I personally highly doubt there are fakes out there. It's the obscurity of the product. The tooling to set up production of a convincing...

I’ve seen a few of her videos; she has a lot of them on YT, and from what I’ve seen is well versed w DIY electrical systems. However...

Hey Joe, just reading through this as I’ve been doing some calculations for cabling and fuses as well recently, and you bring up some...

Good thing they are CALB cells. Strapped, tightly in a box with a bit of firm rubber allowing for slight movement with some level of...

Yes.

I didn't get the DIHOOL (but wish I did due to ring-terminal fit issue) I can tell you the Tomzn breakers have done the job and I have a...

That's baloney. 3 in parallel here and I'll be adding more.

This may do the job for much cheaper. https://batteryhookup.com/products/12-30v-bms-upgrade-to-400a-relay-fuse-kit

Below is a Typical 2 Pack Battery Bank with each pack in Parallel to make up the one battery bank. For detailed wiring information and...

Calb cells with plastic shell are still available. And at 130$/kWh...

I see comments and have to clarify some things, which are concerning, related to wiring DC and in particular battery banks.. Wire Types...

NOTICE: UPDATING November 2022 WIP Good Day everyone, Overview: There is no grid here, no phone lines, cell is so-so (to be polite)...

Please disregard/delete this message. I was attempting to reply in another thread and my keyboard (and my brain) went haywire :fp2 my...

Thank you boB, for taking the time to go over all of that. I greatly appreciate such a thorough reply. I honestly hadn't given that much...

I'm finally "done" my remote off grid set up and can officially join team blue: With very limited space to mount components, Victron...

A typical buck converter MPPT controller will automatically and intrinsically have reverse polarity protection due to the topology of a...

I realize this is an old thread; I happened to find it and read through it bc I am in the middle of redesigning my current system and...

I have created a VenusOS driver that can talk to BMS/Batteries that has serial communications (instead of the normal CANbus)...