I built a 300ah 24v lifepo4 battery using 16 150ah cells and used a Daly 8S 250 amp BMS. So each cell lead is wired to two cells in parallel. The battery works ok but the it cuts off at 24.4V. I haven’t looked to see what the individual cell voltage is.
I’m wondering if I should use a16S BMS. Does it matter that the cells are wired to provide 24v instead of 48v?
Or should I use 2 BMS units?
Last question is, can the cut off voltage of the BMS be adjusted somehow?
I’m wondering if I should use a16S BMS. Does it matter that the cells are wired to provide 24v instead of 48v?
Or should I use 2 BMS units?
Last question is, can the cut off voltage of the BMS be adjusted somehow?