jasonandress
New Member
I'm rewiring my setup my RV. Current system is 12volt, 2 Multiplus II's, 2,900 watts of solar and 8 100amp hour Battleborn batteries. Yes a bit large for 12 volt. I should have opted for 24v when I added the second multi and 4 additional batteries.
Previously I had 8 batteries and were wired diagonally with 2/0 cables. I've added 4 more batteries for a total of 12 and I've purchased Lynx Power Ins and Lynx Distributors and Lynx Shunt.
I will have the following setup. Lynx Distributor + Lynx Distributor + Lynx Shunt + Lynx Power In + Lynx Power In + Lynx Power In. I don't want to wire this many batteries diagonally.
I'll have each battery wired directly to the Lynx Power Ins. My question is will the length of the Lynx Power In (x3) busbar (about 30 inches) affect the battery balance. Meaning although I have each cable exactly the same length but this doesn't count where they are on the busbar. Am I over thinking this or will it be fine since these busbars are big?
Previously I had 8 batteries and were wired diagonally with 2/0 cables. I've added 4 more batteries for a total of 12 and I've purchased Lynx Power Ins and Lynx Distributors and Lynx Shunt.
I will have the following setup. Lynx Distributor + Lynx Distributor + Lynx Shunt + Lynx Power In + Lynx Power In + Lynx Power In. I don't want to wire this many batteries diagonally.
I'll have each battery wired directly to the Lynx Power Ins. My question is will the length of the Lynx Power In (x3) busbar (about 30 inches) affect the battery balance. Meaning although I have each cable exactly the same length but this doesn't count where they are on the busbar. Am I over thinking this or will it be fine since these busbars are big?