svetz
Works in theory! Practice? That's something else
Sounds like you at least did better than here.... total today so far today is is 1.3 kWh (about 3% normal), all thanks to Sally. Of course, far better to have some rain and wind than fire.
Have you looked into the new installer's toolkit? Possibly there's a way to put them in/out of standby?
That would sure be nice! I've only had one do that and I'm pretty sure it was heat related....There should be a way to remote reset the inverters...
Have you looked into the new installer's toolkit? Possibly there's a way to put them in/out of standby?
Mine have always come back after 5 minutes like the spec says. The Envoy doesn't control their 5 min recheck AFAIK. So, due to a simulated outage 11 of 16 panels went off and stayed off? That seems very odd... possibly the Envoy got into a bad state and told them to shut down? Any similarity in the 11? (e.g., east facing)....All this because I tried a power fail simulation...
Brilliant! I'll have to remember that trick.... I covered the panel, it stopped communicating, I waited 5 minutes and then uncovered the panel and it is back making power...
Last edited: