Im having a very difficult time comprehending how to setup my batrium bms, if there's any gurus out there, i sure could use some direction.
I have the Batrium Watchmon Core with the expansion 3, 4x Cellmate K9's, 4x 225amp ABB SACE3 shunt trip breakers and 64x 280ah CATL lifepo4 cells. Each breaker is wired to a separate relay, 1 on the core, and the other 3 on the expansion. There are 16 cells on each k9, and 16 cells on each breaker, so it's 4 individual 48v 16s batteries that are paralleled after the breakers. I'm trying to figure out how to make the the batrium, or more specifically each k9, control each relay to control the corresponding shunt trip breaker. the toolkit software will not let me select critical fault for more than 1 relay, and I cant find anywhere that it lets me separate the 4 individual 48v batteries. If I have a faulty/runaway cell, I want the system to be able to isolate that battery and still be able to operate on the other 3, not completely shut down.
I have the Batrium Watchmon Core with the expansion 3, 4x Cellmate K9's, 4x 225amp ABB SACE3 shunt trip breakers and 64x 280ah CATL lifepo4 cells. Each breaker is wired to a separate relay, 1 on the core, and the other 3 on the expansion. There are 16 cells on each k9, and 16 cells on each breaker, so it's 4 individual 48v 16s batteries that are paralleled after the breakers. I'm trying to figure out how to make the the batrium, or more specifically each k9, control each relay to control the corresponding shunt trip breaker. the toolkit software will not let me select critical fault for more than 1 relay, and I cant find anywhere that it lets me separate the 4 individual 48v batteries. If I have a faulty/runaway cell, I want the system to be able to isolate that battery and still be able to operate on the other 3, not completely shut down.