corn18
Village Idiot
- Joined
- Sep 9, 2021
- Messages
- 667
Since I am installing a Victron Energy MultiPlus II 12/3000/12x2 and I have a Victron 712 shunt, I think I want to swap out my two Rich Solar SCCs for a single Victron. I have 4 panels on my RV roof, 2 sets of 2S. Each 2S has its own 10ga wire pair running down to my basement where I have 2 Rich Solar 100/40 MPPT SCCs.
I have a Cerbo GX and VE 100/50 smart solar MPPT on the way. I was going to plug the MPII, 712 shunt and SCC into the Cerbo GX.
Ok, here's my question: How do I hook up the VE SCC? I have 2 sets of 10ga wire coming down from the roof. Can I just hook both of them up to the Victron SCC? Would probably use a bus I guess to do the parallel connection. Is it smart to go from 2 separate controllers to a single controller? I want to end up with the 7" GX display in the camper for all in one monitoring. I guess I could go with 2xVictron SCCs if I have to.
Appreciate your thoughts.
Current setup:
I have a Cerbo GX and VE 100/50 smart solar MPPT on the way. I was going to plug the MPII, 712 shunt and SCC into the Cerbo GX.
Ok, here's my question: How do I hook up the VE SCC? I have 2 sets of 10ga wire coming down from the roof. Can I just hook both of them up to the Victron SCC? Would probably use a bus I guess to do the parallel connection. Is it smart to go from 2 separate controllers to a single controller? I want to end up with the 7" GX display in the camper for all in one monitoring. I guess I could go with 2xVictron SCCs if I have to.
Appreciate your thoughts.
Current setup: