Help trying to get cerbo to recognize seplos bms

[brandonboosted]

Trying to connect my victron multi ii’s to my seplos mason batteries, it won’t pop up on the cerbo has anyone had this or know if I am missing something?

 

[Brucey]

What cable and port are you using?

 

[brandonboosted]

What cable and port are you using?

Using standard cat cable from master seplos bms can to victron bms can

 

[Brucey]

Using standard cat cable from master seplos bms can to victron bms can

I think you need this: Victron VE.Can to CAN-bus BMS type B Cable

Can you connect a Seplos BMS 48V 100A 16s directly to a Cerbo GX? - Victron Community

community.victronenergy.com

 

[brandonboosted]

I think you need this: Victron VE.Can to CAN-bus BMS type B Cable

Can you connect a Seplos BMS 48V 100A 16s directly to a Cerbo GX? - Victron Community

community.victronenergy.com

View attachment 201024

Thank you for that, that forum had the wire diagram for that cable I will try to make that and post back

 

[brandonboosted]

I think you need this: Victron VE.Can to CAN-bus BMS type B Cable

Can you connect a Seplos BMS 48V 100A 16s directly to a Cerbo GX? - Victron Community

community.victronenergy.com

View attachment 201024

Still no luck, I don’t see any sent or received packets either

 

[Brucey]

Still no luck, I don’t see any sent or received packets either

Did you see this post?

 

[brandonboosted]

Did you see this post?

View attachment 201075

Yes I wired it exactly to this

 

[cdsolar]

Try the different speeds and such.

Services->can0->Can-bus BMS (500 kbit/s) works for me. You probably don't want the VE profiles.Your mileage may vary as I am using EG4 batteries with their BMS.

Also look at Services->can0->Network status to see if anything is seen at all.

 

[brandonboosted]

I tried that as well, I have 2 10C version and 1 10E version bms. They are all running ver 2.7 I’m going to try to get them to this new 2.8 and hope that does something, seems that’s what everyone else that’s working is using for firmware version.

 

[brandonboosted]

Update, used the can dip switch settings and for some reason had to reboot my cerbo and I have data! My only problem now is that battery #3 won’t show up on the computer software but shows on the can system in the vrm, I’m hopeful that the update to 2.8 will resolve this.

 

[gocfella]

Can I ask will a Victron VE.CAN to CAN-BUS Type A cable work between GX and Seplos V3 bms would you guys know?