With the Bluetooth dongle, you can change the inverter status -on,off, charger only, & inverter only. You can also change the input amps - from 50amps down to 7.5amps (I believe that’s the numbers).
If you have a Cerbo or other GX device attached you can make all those changes in the Cerbo.
The MK3 to USB is for initial programming of the unit - you could also make those changes there too.
Pass through mode will happen automatically when the unit is on. (And maybe in charger mode - I don’t remember this area because I never use it).
If you have a Cerbo or other GX device attached you can make all those changes in the Cerbo.
The MK3 to USB is for initial programming of the unit - you could also make those changes there too.
Pass through mode will happen automatically when the unit is on. (And maybe in charger mode - I don’t remember this area because I never use it).