Solarfun4jim
Solar seduced :-)
Im soon to be doing a 'capacity test' on my 8s battery bank. I wish to use my chargery BMS8T to monitor the cells but i do not have a dc relay for discharge cut off. I assume if i take the positive and negative wires from the discharge relay and simply connect them across a terminal block, then on low voltage disconnect situation, it will simply terminate the current through the block. However, at the same time, the buzzer and the warning 'led' should sound the alarm and at that point i can manually disconnect the capacity tester. I would be using the calibrated shunt supplied by chargery, so i presume no further calibration should be needed.
Anyone see any issues in monitoring my individual cell voltages this way and reacting immediately on alarm signal LVD?
Anyone see any issues in monitoring my individual cell voltages this way and reacting immediately on alarm signal LVD?