cwilken
New Member
- Joined
- May 21, 2021
- Messages
- 73
My son just finished a 14S10P DIY battery made from 14S 10P cells from skateboards (battery hookup)
It is 58 volts and about 30amp hours. We tested it out for a few days in this old tool box but I would like to make a nice home for it in this Ammo Can. I believe these cells are not quite as safe as lithium iron phosphate.
If anyone could share a picture of their build on one of these or their ideas. It has an air tight seal and very HD.
Any way to :
1. Put terminals comming out the side that are isolated from metal box (finding isolated product is hard)
2. Isolate and insulate the BMS from battery (temperature)
3. evacuate air from inside and put heat sinks to metal walls???
4. Cooling system? I would like to keep it outside my house along a north facing wall.
It is 58 volts and about 30amp hours. We tested it out for a few days in this old tool box but I would like to make a nice home for it in this Ammo Can. I believe these cells are not quite as safe as lithium iron phosphate.
If anyone could share a picture of their build on one of these or their ideas. It has an air tight seal and very HD.
Any way to :
1. Put terminals comming out the side that are isolated from metal box (finding isolated product is hard)
2. Isolate and insulate the BMS from battery (temperature)
3. evacuate air from inside and put heat sinks to metal walls???
4. Cooling system? I would like to keep it outside my house along a north facing wall.