Sol-Ark 15K Back to No Battery

[Tulex]

Adding a third battery to my Sol-Ark 15K. This means moving cables to a busbar, which means I need to take my batteries off line.
I can't find a way to tell the inverter that I don't have batteries. I checked "no battery", which is how I ran it for the first month before adding a battery, but the alarm sounds. What do I have to do to run without batteries for a period without alarm?

 

[Crowz]

Under Battery setup, select no Battery & disable Activate Battery (or the system will beep)

 

[Tulex]

Under Battery setup, select no Battery & disable Activate Battery (or the system will beep)

Tried that, alarm still sounds.

 

[Tulex]

OK, tried it again, heard a click, alarm sounded, about a minute later, another click, then about a minute later, alarm went off.

Thanks.

 

[Crowz]

Maybe this ?

Case #13: System is beeping​

Symptom	System is beeping.
Cause	A system alarm has been triggered. There is not battery connected.
Resolution	Check the system alarms menu to see which alarm has been triggered. Most alarms will self-reset. If not using a battery, select no battery and disable activate batt in Batt menu. Turn off the center button, remove AC Grid and PV Power for the 30s (screen is dead), and then power up to fully reset the system.

 

[Crowz]

OK, tried it again, heard a click, alarm sounded, about a minute later, another click, then about a minute later, alarm went off.

Thanks.

Glad its working right now.