Aussie Collie
New Member
- Joined
- Dec 18, 2021
- Messages
- 27
Hello,
I am looking at buying a Epever Tracer 5415AN controller. It has a rated charging current of 50 amps.
I am new to lithium. Question is: Would this controller be suited to the two Enercore LiFePO4 batteries I have?
I plan to set them up in series for 24v, which is ok for these according to the datasheet (max 48v).
Battery specs:
Rated Capacity: 100Ah
Nominal Voltage: 12.8V
Cut-off Voltage: 9.2V
Energy: 1280Wh
Max. Charge Voltage: 14.4~14.6V
Max. Charge Current: 50A (≤ 0.5C)
Max. Continues Discharge current: 100A (≤ 1C)
Max. Discharge Current: 2.3 Seconds 200A
Panels will be 2 x 400 watt in series. 41.2 Voc and 12.28 Isc each panel.
Any advice would be appreciated.
Collie?
I am looking at buying a Epever Tracer 5415AN controller. It has a rated charging current of 50 amps.
I am new to lithium. Question is: Would this controller be suited to the two Enercore LiFePO4 batteries I have?
I plan to set them up in series for 24v, which is ok for these according to the datasheet (max 48v).
Battery specs:
Rated Capacity: 100Ah
Nominal Voltage: 12.8V
Cut-off Voltage: 9.2V
Energy: 1280Wh
Max. Charge Voltage: 14.4~14.6V
Max. Charge Current: 50A (≤ 0.5C)
Max. Continues Discharge current: 100A (≤ 1C)
Max. Discharge Current: 2.3 Seconds 200A
Panels will be 2 x 400 watt in series. 41.2 Voc and 12.28 Isc each panel.
Any advice would be appreciated.
Collie?