I don't think they actually want you to measure the resistance, however like the diode or continuity setting (beep setting) it applies a small voltage to wake up the BMS.So, I’m back in my off-grid house to do some more testing with the BMS. The Beep-setting on the Multimeter did not do the trick for med. Just says OL and no beep.
So, I read thru the instructions one more time an in step 4 (the step after connecting balance-leads but before connecting B- to batter -) they want you to measure the resistance between the B-and P-. When I do that it I get 0,347 (picture). I am not convinced that I get a good/ok value. I have also taken a picture of the instruction. (The instruction says 0,0 Q-5Q.
What do you think? Is this a OK value?
I think you have a bad BMS, sorry.