This is an old post, but, seplos will be happy to send dimension's specification to you.Very good. Thanks friend
This is an old post, but, seplos will be happy to send dimension's specification to you.Very good. Thanks friend
hello, can you please give a feed back on the current box design for LP280K cells and seplos BMS => box design .I think I will probably do my 112 order again for 224 total cells but that’s it. That would be over 200KWH at that point. The enclosure you built are fantastic but I just don’t have the patience for that. I compress them and put them on a rack. The BMS and Positive connect to busbars then to breaker/combiners.
you can find it on aliexpress cheaperHello,
since there is so good discussion here about the Seplos BMS I think I am right here with my question.
Can any of you post me a link where I can buy this "RJ45 to USB adapter for SEPLOS BMS". Seplos wants over $60 for this simple adapter with shipping and tax. I'm guessing there should be a compatible one available on Amazon or somewhere else? All the adapters I could find were USB to Ethernet. I suspect that these will not work.
Thanks for any advice.
And as a suggestion for all those who want to buy a Seplos BMS, order the adapter at the same time.
14s use for battery 3.7V typeWell you were right, I got a reply and apparently they sent me a 14S harness by mistake. Who the hell makes 14S packs? And why do that? Wouldn't we cut off our own 2 wires if we decided to build a 14S?
@Seplos Chris Ren FYI.
Have you got the bms to work with the Cerbo gx? I’m thinking of ordering 3 bms’es, and want to get it right.thanks a lot guys for the fast help
The adaptor will be used for BMS setup.
For the CAN Bus communication to the Victron Cerbo I will use the original Victron type A cabel.
the bms has pylontech compatible CANBUS, so it should workHave you got the bms to work with the Cerbo gx? I’m thinking of ordering 3 bms’es, and want to get it right.
Have you done the required calibration which is printed on the box that the BMS came in?Capacity went from 100% to 10% within a minute
are cells are balanced
please can anyone help? as seplos staff now are in Hollidays
its connected to deye inverter using can
i have ofcourse didHave you done the required calibration which is printed on the box that the BMS came in?
Why 'of course'?i have ofcourse did
sorry bad englishWhy 'of course'?
Ok, no problem.sorry bad english
am telling you yes i have did it and i have been using it normally for the past month
untill now i had this problem
yesOk, no problem.
Have you got a serial connection from the BMS to a PC running Seplos' Battery Monitor software?
Can you take a screenshot (shift-win-S) and post it here, showing all battery voltages, capacity, etc?