Jorvs
New Member
- Joined
- Feb 21, 2021
- Messages
- 14
bought new cells eve 280 cells fully charged them and then bottom balance them connected them in parallel to bottom balance
the amp = 19 -21 mostly and U use a hair dryer as my load
I just notice that one cell no 3 is already 3.6 while others are not seem there voltages way off is here the image
sorry dint save a screen shot when it was full charge but as you can see here that cell 3 voltage is really high this image is when I just got started to capacity test
after 6 hours this happened the test was finished the cell 1 hit 2.5v and the test was done
can some tell me if I did something wrong..
I tested my old 100ah cells and it hit 94ah pretty close to its capacity this ones way off
the 2 other cells seem fine? can some had this experience may be I did something wrong? and my cells were actually good
the amp = 19 -21 mostly and U use a hair dryer as my load
I just notice that one cell no 3 is already 3.6 while others are not seem there voltages way off is here the image
sorry dint save a screen shot when it was full charge but as you can see here that cell 3 voltage is really high this image is when I just got started to capacity test
after 6 hours this happened the test was finished the cell 1 hit 2.5v and the test was done
can some tell me if I did something wrong..
I tested my old 100ah cells and it hit 94ah pretty close to its capacity this ones way off
the 2 other cells seem fine? can some had this experience may be I did something wrong? and my cells were actually good