Here's a question/ suggestion. I just installed an 18kpv with 3 indoor batteries. It is being used off grid. No feed back to grid. (actually there is no grid connection at all.)
Would it be possible in future monitoring app and firmware updates to do something like the following?
Before you input any setting it would ask a couple questions such as:
GRID SELL BACK, GRID ATTACHED NO SELL BACK, OFF GRID (NO GRID ATTACHED)
Then you would enter the settings options. Only relevant options would remain showing.
I am new to this, but seeing all the discharge settings etc that as far as I understand don't apply to me is confusing. Makes me not sure if I have it correct. I went with the 18kpv over multiple 6000xps for several reasons. I had a 3000ehv and despite its rudimentary settings it did nearly everything I needed in a reasonably simple way, just limited on input.
Thanks.